Skip to content
LicenseReciprocity

Contractor License from Nevada to Georgia: Does It Transfer? (2026)

Last verified: 2026-09-01 · source: Georgia State Licensing Board for Residential and General Contractors (Office of Secretary of State) ↗

A contractor license transfers from Nevada to Georgia by endorsement — there is no automatic reciprocity, but you do not start over. Apply to the Georgia State Licensing Board for Residential and General Contractors (Office of Secretary of State), verify your Nevada license, and meet Georgia's endorsement requirements. Georgia accepts the NASCLA Accredited Commercial General Building Examination for the general-contractor trade exam. Georgia licenses residential (residential-basic/light-commercial) and general contractors as SEPARATE classes through the State Licensing Board for Residential and General Contractors.

Verify this exact pair in the checker

Same data, interactive — with share link and board links.

Run the Reciprocity Checker →

Verdict

Licensure by endorsement

Georgia does not have a trade agreement covering Nevada for the selected trade, so this move runs on Georgia's case-by-case endorsement process. If you do commercial general-building work, check whether Georgia accepts the NASCLA exam — passing it once can replace the trade exam here and in about fourteen other states. Electricians should check Georgia's NERA status.

What changes, Nevada → Georgia

Side-by-side: Nevada vs Georgia (Contractor (GC/electrical/plumbing/HVAC)), verified 2026-09-01
Nevada (current)Georgia (destination)
Application fee$900 ($900 is what every applicant pays to reach an issued Nevada licence. It is two sequential stages of one pathway, not two alternatives: a $300 nonrefundable application fee due with the application, then a $600 biennial licence fee payable on approval before the licence is issued (and again every two years at renewal). Contractors performing qualified residential work also pay a Residential Recovery Fund assessment before initial issuance and at each two-year renewal - $200 up to a $1,000,000 limit, $500 over $1,000,000, $1,000 for unlimited licences - excluded from the range because it depends on the classification and monetary limit granted. The surety or cash bond ($2,000 or higher as set by the board, with a $200 biennial administrative fee on cash bond deposits), the Nevada Business and Law examination, financial review, and fingerprint processing are all separate.)Board fee applies; specific figure not verified (board site blocked)
Processing timeNot published as a fixed range.Not verified
Licensing authorityNevada State Contractors BoardGeorgia State Licensing Board for Residential and General Contractors (Office of Secretary of State)

The destination column is what you must satisfy — Georgia sets the rules for this move.

Step by step

  1. Confirm Georgia's current requirements on the Georgia State Licensing Board for Residential and General Contractors (Office of Secretary of State) website (linked below) — rules change.
  2. Submit the endorsement application to the Georgia State Licensing Board for Residential and General Contractors (Office of Secretary of State).
  3. Arrange license verification from your current state.
  4. Hold an equivalent contractor license in good standing (used toward reciprocity/experience).
  5. Pass the Georgia Business and Law examination.
  6. Provide financial-responsibility documentation and required insurance.
  7. Pay the fees (Board fee applies; specific figure not verified (board site blocked)) and allow Not verified.

Official links

Related guides

Frequently asked questions

Does Georgia accept a Nevada contractor license?

A contractor license transfers from Nevada to Georgia by endorsement — there is no automatic reciprocity, but you do not start over. Apply to the Georgia State Licensing Board for Residential and General Contractors (Office of Secretary of State), verify your Nevada license, and meet Georgia's endorsement requirements. Georgia accepts the NASCLA Accredited Commercial General Building Examination for the general-contractor trade exam. Georgia licenses residential (residential-basic/light-commercial) and general contractors as SEPARATE classes through the State Licensing Board for Residential and General Contractors.

What still applies even if reciprocity covers my trade?

Georgia's business and law exam, financial statement, bond, and registration — reciprocity waives the trade exam only, not these.

What does the Nevada-to-Georgia move cost and how long does it take?

Board fee applies; specific figure not verified (board site blocked); processing Not verified.

Would the NASCLA exam help for this move?

If you do commercial general-building work, possibly — about 15 states accept the NASCLA Accredited Commercial General Building exam toward licensure. Check whether Georgia is one on the Georgia State Licensing Board for Residential and General Contractors (Office of Secretary of State) site.

Sources

Primary sources only — official boards and compact commissions. Data last verified 2026-09-01.

Reviewed by Billy Reiner, Editor · verified against primary sources 2026-09-01

How we verify · All sources · spot an error? [email protected]